Stencil maker
Turn an image into a one-colour stencil whose islands stay attached — bridges added automatically, ready to cut.
The island problem
Cut the letter O out of a sheet and its centre falls away; spray through it and you get a filled dot. Every enclosed shape in a stencil has this problem, and in a portrait there can be dozens of them. Traditional stencil cutters solve it by hand with bridges — small ties that hold each island in place.
Stencil mode finds every enclosed island after tracing and cuts the shortest bridge that connects it to the surrounding material. The result note tells you how many bridges were added, so you can zoom in and check them before cutting.
Getting a good two-tone image
- Crop tightly and remove the background if it is busy.
- Move Threshold until the subject reads at a glance; squint to judge.
- Raise smoothing so cut lines are calm and easy to follow with a blade.
- Check the cut-file report for pieces too small or narrow to survive.
Bridges you barely notice
Bridges are placed at the narrowest gap between an island and its surround, which keeps them short. Set their width to roughly the thickness of the thinnest line you want to keep; for spray stencils, a little wider than you think, since thin bridges tear.
Related cutting tools
Stencil questions
What is a stencil bridge?
A thin strip of material left uncut so an enclosed piece — the middle of an O, the eye in a portrait — stays attached to the rest of the stencil instead of falling out.
Can I control bridge width?
Yes. Bridge width is a slider in the Vectorize step. Wider bridges are sturdier; narrower ones are less visible in the finished spray or print.
Does it work for photos?
Yes. A photo is reduced to two tones first. Adjust Threshold until the face or object reads clearly in black and white, then let the stencil pass add bridges.
What material can I cut it from?
Anything your cutter handles: vinyl, mylar, card, plywood. Export SVG for craft cutters or DXF for lasers and CNC.
