Guide

SVG for cutting machines

A screen forgives a messy SVG; a blade or a laser does not. These are the properties that separate a file that cuts cleanly from one that wastes material.

Closed paths

A cutter follows outlines. An open path — a line that does not return to its start — has no inside, so a cutter may cut it as a slit or refuse to fill it. Every shape intended as a piece should be a closed loop. The cut-file check counts open paths and closes them with one click.

No hidden overlaps

Many tracers stack colours: a big shape at the back, smaller shapes on top. On screen it looks correct. To a cutter, the hidden part of the back shape is still there and still gets cut. Use cut-out layering, where every visible area belongs to exactly one shape and shapes meet edge to edge.

Minimum sizes

Every material has a smallest piece you can weed and a narrowest strip that survives cutting. For adhesive vinyl, pieces below about 2 mm across are usually lost; strips narrower than about 0.6 mm tear. Set your real output size in the Export step and the check judges pieces at that size. Remove what will not survive before cutting, not after.

Islands and bridges

When you cut a shape out of a sheet — a stencil, a laser-cut sign — enclosed pieces fall out. The middle of an O, the triangle in an A. Stencil mode adds bridges, thin ties that keep each island connected. For vinyl, where you keep the shapes rather than the sheet, islands are fine and no bridges are needed.

Fewer nodes, smoother cuts

A blade or laser head slows at every direction change. A trace with thousands of tiny segments cuts slowly and can leave a rough edge. Raise smoothing, and use Simplify in the Edit step; the node count in Inspect should drop while the shape stays the same.

Formats

SVG
Craft cutters and most laser software. Set a physical width in mm or inches so it imports at the right size.
DXF
CAD, CNC and many laser workflows. Written as closed polylines, one layer per colour, in the units you choose.
PDF
Print-and-cut workflows and older software.

Pre-cut checklist

  • All paths closed.
  • Cut-out layering — no overlapping colours.
  • No pieces too small or strips too narrow at your output size.
  • Bridges added if you are cutting a stencil.
  • Physical size set before export.

Make the file